BS-MP20 Series Firmware Version 2.0.6.8

Name:          BS-MP20 series firmware
Version:       2.0.6.8
Filename:      bsmp20-2068.zip
Size:          774,772 bytes
Date:          May 21, 2018
Models:        BS-MP20 series
Copyright:     Buffalo Inc.
Distribution:  ZIP archive
Condition:     No reprinting allowed.
Manual:        Manual packed with the product

---------------------
[Software Description]
This firmware is for the BS-MP20 series only.
If the current firmware version is version 1.0.3.2, update the firmware to version 2.0.5.3 before updating to this version.

[How to Update]
For instructions on how to update the firmware, refer to the user manual available from the Buffalo website.

* Do not disconnect the power cable while updating.

Caution:
 - This firmware is for the BS-MP20 series only. Do not use this firmware with any other products such as BS-XP20 series.
 - After updating the firmware to this version, the firmware cannot be changed to version 2.0.5.3 or earlier. 

Restriction:
The firmware cannot be updated while jumbo frames are enabled on your computer. Disable jumbo frames before updating the firmware. Refer to your computer's manual on how to configure jumbo frame settings.

[Release Notes]
Version 2.0.6.8
 - Fixed the issue where some ports' links did not re-establish after rebooting.
* This version makes the same change as version 2.0.5.3. If updating version 2.0.5.3 to this version, only the version number will change.

Version 2.0.5.3
 - Fixed the issue where the switch reboots when you press and hold the reset button for less than 3 seconds. (The switch's setting was not reset with the reboot.)
 - Fixed the issue where some ports' links did not re-establish after rebooting.

Version 2.0.5.2
 - Fixed the issue where the switch reboots when you press and hold the reset button for less than 3 seconds. (The switch's setting was not reset with the reboot.)
* Version 2.0.5.2 had been released from 23rd January 2018 until 23rd April 2018. The release has been discontinued because version 2.0.5.2 caused the issue that some ports' links did not re-establish after rebooting.
If the current firmware version is version 2.0.5.2, update the firmware to version 2.0.6.8.

Version 1.0.3.2
  Initial release